Hi All,
I am using the Final Configuration script - https://deploymentresearch.com/Research/Post/427/Final-Configuration-for-MDT-2013-Lite-Touch-now-wit… which is set as an install application as part of my task sequence.
Captured WIM deploys fine, gets to desktop then reboots and runs the final config script which allows for OOBE on the next reboot for manual join of Azure AD.
Did anyone use the script before? Can you configure which steps are shown/automate them e.g. auto allow find my device and not show it as a step etc.?
Also after the device has rebooted how can I issue an auto-reboot command from the task sequence following the install of ‘Final Configuration for MDT’
Help is must be appreciated to me because this stuff is totally taking me out of here.
So please Give me the right address which can guide me to the solution.
Thanks in advance
I hope it will work properly and after this, it will work fine.
